AP Commands 301Nortel WLAN—Security Switch 2300 Series Command Line ReferenceDefaults The default maximum transmit threshold for AP radios is 2000 ms (2 seconds).Access Enabled.Usage You must disable all radios that are using a radio profile before you can change parameters in theprofile. Use the set radio-profile mode command.Examples The following command changes the maximum transmit threshold for radio profile rp1 to4000 ms:WSS# set radio-profile rp1 max-tx-lifetime 4000success: change accepted.See Also• set radio-profile mode on page 291• set radio-profile max-rx-lifetime on page 290• show radio-profile on page 376set radio-profile modeCreates a new radio profile, or disables or reenables all AP radios that are using a specific profile.Syntax set radio-profile name [mode {enable | disable}]Defaults Each radio profile that you create has a set of properties with factory default values that you canchange with the other set radio-profile commands in this chapter. Table 37 lists the parameters controlled by aradio profile and their default values.radio-profile name Radio profile name of up to 16 alphanumeric characters, with no spaces.Use this command without the mode enable or mode disable option tocreate a new profile.mode enable Enables the radios that use this profile.mode disable Disables the radios that use this profile.Table 4: Defaults for Radio Profile ParametersParameter DefaultValueRadio Behavior WhenParameter Set To DefaultValueactive-scan enable Sends probe any requests (proberequests with a null SSID name) tosolicit probe responses from otheraccess points.auto-tune enable Allows dynamic configuration ofchannel and power settings by WSSSoftware.beacon-interval 100 Waits 100 ms between beacons.
