232 Mobility Domain CommandsNN47250-100 (Version 02.51)set mobility-domain mode secondary-seed domain-name seed-ipCreates a Mobility Domain by setting the current WSS as the secondary seed device and naming the Mobility Domain.Syntax set mobility-domain mode secondary-seed domain-name domain-name seed-ip seed-ipDefaults None.Access Enabled.History Introduced in WSS Software Version 6.0.Usage Before you use this command, the current WSS must have its IP address set with the set system ip-address command. After you enter this command, all Mobility Domain traffic is sent and received from thespecified IP address.Examples Following is the example of secondary-seed domain-name seed-ipWSS# set mobility-domain mode secondary-seed domain-name spl seed-ip 198.164.1.8Success: change accepted.show mobility-domain configDisplays the configuration of the Mobility Domain.Syntax show mobility-domain configDefaults None.Access Enabled.Examples The following command displays the Mobility Domain configuration:WSS# show mobility-domain configThis WSS is a member, with seed 192.168.14.6See Also• clear mobility-domain on page 218• set mobility-domain member on page 219• show mobility-domain on page 222show mobility-domainOn the seed WSS, displays the Mobility Domain status and members.mob-domain-name Name of the Mobility Domain. Specify between 1 and 32 characters withno spaces.
