AP Commands 251Nortel WLAN—Security Switch 2300 Series Command Line Referenceclear ap boot-configurationRemoves the static IP address configuration for a AP.Syntax clear ap boot-configuration ap-numDefaults None.Access Enabled.History Introduced in WSS Software 4.1.Option dap removed in 6.0.Usage When the static IP configuration is cleared for a AP, the next time the AP is rebooted, it uses thestandard boot process.Examples The following command clears the static IP address configuration for AP 1.WSS# clear ap 1 boot-configurationThis will clear specified AP devices. Would you like to continue? (y/n) [n]ysuccess: static info cleared.• set ap boot-configuration ip on page 251• set ap boot-configuration switch on page 255• set ap boot-configuration vlan on page 256• show ap boot-configuration on page 370clear ap radio load-balancing groupRemoves an AP radio from its load-balancing group.Syntax clear ap ap-number radio {1 | 2} load-balancing groupDefaults None.Access Enabled.History Introduced in WSS Version 6.0.Usage If an AP radio has been assigned to an RF load balancing group, you can use this command toremove the AP radio from the group.ap ap-num Number of the AP for which you are clearing static IP information.ap ap-number Index value that identifies the AP on the WSS.radio 1 Radio 1 of the AP.radio 2 Radio 2 of the AP. (This option does not apply to single-radio models.)
