System Services Commands 65Nortel WLAN—Security Switch 2300 Series Command Line Referenceclear promptResets the system prompt to its previously configured value. If the prompt was not configured previously, this commandresets the prompt to its default.Syntax clear promptDefaults None.Access Enabled.Examples To reset the prompt, type the following command:wildebeest# clear promptsuccess: change accepted.WSS#See Also set prompt on page 62. (For information about default prompts, see“Command Prompts” on page 10.)clear systemClears the system configuration of the specified information.Syntax clear system [contact | countrycode | idle-timeout | ip-address | location | name]Defaults None.Access Enabled.HistoryCaution! If you change the IP address, any currently configured Mobility Domainoperations cease. You must reset the Mobility Domain.contact Resets the name of contact person for the WSS to null.countrycode Resets the country code for the WSS to null.idle-timeout Resets the number of seconds a CLI management session can remain idleto the default value (3600 seconds).ip-address Resets the IP address of the WSS to null.location Resets the location of the WSS to null.name Resets the name of the WSS to the default system name, which is WSS-mm-nnnnnn, where mm is the model number and nnnnnn is thelast 6 digits of the switch’s MAC address.Version 4.1 Option idle-timeout added.
