230 Mobility Domain CommandsNN47250-100 (Version 02.51)success: change accepted.WSS# set mobility-domain member 192.168.1.10success: change accepted.See Also• clear mobility-domain member on page 218• show mobility-domain config on page 222set mobility-domain mode member seed-ipOn a nonseed WSS, sets the IP address of the seed WSS. This command is used on a member WSS to configure it as amember. If the WSS is currently part of another Mobility Domain or using another seed, this command overwrites thatconfiguration.Syntax set mobility-domain mode member seed-ip ip-addr key hex-bytesDefaults None.Access Enabled.HistoryExamples The following command sets the current WSS as a nonseed member of the Mobility Domainwhose seed has the IP address 192.168.1.8:WSS# set mobility-domain mode member seed-ip 192.168.1.8mode is: memberseed IP is: 192.168.1.8See Also• clear mobility-domain on page 218• show mobility-domain config on page 222set mobility-domain mode member secondary-seed-ipThis command is used on a member WSS to configure it as a member of secondary seed.ip-addr IP address of the Mobility Domain member, in dotted decimal notation.key hex-bytes Fingerprint of the public key to use for WSS-WSS security. Specify thekey as 16 hexadecimal bytes. Use a colon between each byte, as in thefollowing example:00:11:22:33:44:55:66:77:88:99:aa:bb:cc:dd:ee:ffVersion 5.0 Option key hex-bytes added.
