260 AP CommandsNN47250-100 (Version 02.51)Usage High bias is preferred over low bias. Bias applies only to WSSs that are indirectly attached to the APthrough an intermediate Layer 2 or Layer 3 network. An AP always attempts to boot on AP port 1 first, and ifa WSS is directly attached on AP port 1, the AP always boots from it.If AP port 1 is indirectly connected to WSSs through the network, the AP boots from the switch with the highbias for the AP. If the bias for all connections is the same, the AP selects the switch that has the greatestcapacity to add more active APs. For example, if an AP is dual homed to two 2380 switches, and one of theswitches has 50 active APs while the other switch has 60 active APs, the new AP selects the switch that hasonly 50 active APs.If the boot request on AP port 1 fails, the AP attempts to boot over its port 2, using the same process describedabove.AP selection of a WSS is sticky. After an AP selects a WSS to boot from, the AP continues to use that switchfor its active data link even if another switch configured with high bias for the AP becomes available.The following command changes the bias for a AP to low:WSS# set ap 1 bias lowsuccess: change accepted.See Also show ap config on page 344set ap blinkEnables or disables LED blink mode on an AP to make it easy to identify. When blink mode is enabled on AP-xxxmodels, the health and radio LEDs alternately blink green and amber. When blink mode is enabled on an AP2750, the11a LED blinks on and off. By default, blink mode is disabled.Syntax set {ap port-list | ap {ap-num | auto}}blink {enable | disable}Defaults LED blink mode is disabled by default.Access Enabled.Historyap port-list List of ports connected to the APs on which to turn blink mode on or off.ap ap-num Number of a AP on which to turn blink mode on or off.ap auto Configures blink mode for the AP configuration profile. (See set ap autoon page 245.)enable Enables blink mode.disable Disables blink mode.Version 4.0 Option auto added for configuration of the AP configurationprofile.Version 6.0 Optional dap removed.
