Snoop Commands 579Nortel WLAN—Security Switch 2300 Series Command Line ReferenceDefaults Snoop filters are unmapped by default.Access Enabled.History Introduced in WSS Software Version 4.0.Usage You can map the same filter to more than one radio. You can map up to eight filters to thesame radio. If more than one filter has the same observer, the AP sends only one copy of a packetthat matches a filter to the observer. After the first match, the AP sends the packet and stopscomparing the packet against other filters for the same observer.If the filter does not have an observer, the AP still maintains a counter of the number of packets that match thefilter. (See show snoop stats on page 572.)Examples The following command maps snoop filter snoop1 to radio 2 on AP 3:WSS# set snoop map snoop1 ap 3 radio 2success: change accepted.See Also• clear snoop map on page 566• set snoop on page 567• set snoop mode on page 569• show snoop map on page 571• show snoop stats on page 572set snoop modeEnables a snoop filter. A snoop filter does not take effect until you map it to an AP radio and enable the filter.Examples set snoop {filter-name | all}mode {enable [stop-after num-pkts] | disable}filter-name Name of the snoop filter.ap ap-num Number of a AP to which to map the snoop filter.radio 1 Radio 1 of the AP.radio 2 Radio 2 of the AP. (This option does not apply to single-radio models.)filter-name | all} Name of the snoop filter. Specify all to enable all snoop filters.enable[stop-after num-pkts] Enables the snoop filter.The stop-after option disables the filter after the specifiednumber of packets match the filter. Without the stop-afteroption, the filter operates until you disable it or until the AP isrestarted.disable Disables the snoop filter.
