324 AP CommandsNN47250-100 (Version 02.51)set service-profile cipher-wep104Enables dynamic Wired Equivalent Privacy (WEP) with 104-bit keys, in a service profile.Syntax set service-profile name cipher-wep104 {enable | disable}Defaults 104-bit WEP encryption is disabled by default.Access Enabled.History Introduced in WSS Software Version 3.0.Usage To use 104-bit WEP with WPA clients, you must also enable the WPA IE.When 104-bit WEP in WPA is enabled in the service profile, radios managed by a radio profile that is mapped to theservice profile can also support non-WPA clients that use dynamic WEP.To support WPA clients that use 40-bit dynamic WEP, you must enable WEP with 40-bit keys. Use the set service-profile cipher-wep40 command.Microsoft Windows XP does not support WEP with WPA. To configure a service profile to provide dynamic WEP forXP clients, leave WPA disabled and use the set service-profile wep commands.To support non-WPA clients that use static WEP, you must configure static WEP keys. Use the set service-profile wepkey-index command.Examples The following command configures service profile sp2 to use 104-bit WEP encryption:WSS# set service-profile sp2 cipher-wep104 enablesuccess: change accepted.See Also• set service-profile cipher-ccmp on page 312• set service-profile cipher-tkip on page 313• set service-profile cipher-wep40 on page 315• set service-profile wep key-index on page 342• set service-profile wpa-ie on page 342• show service-profile on page 380name Service profile name.enable Enables 104-bit WEP encryption for WPA clients.disable Disables 104-bit WEP encryption for WPA clients.
