262 AP CommandsNN47250-100 (Version 02.51)• show ap boot-configuration on page 370set ap boot-configuration mesh modeEnables WLAN mesh services on the AP.Syntax set ap ap-number boot-configuration mesh mode {enable | disable}Defaults Disabled.Access Enabled.History Introduced in WSS Version 6.0.Usage Use this command to enable WLAN mesh services for an Mesh AP. Prior to deploying the Mesh APin its final untethered location, you must connect the AP to an WSS switch and enter this command toconfigure the AP for mesh services.Examples The following command enables WLAN mesh services for AP 7:WSS# set ap 7 boot-configuration mesh mode enablesuccess: change accepted.See Also• set ap boot-configuration mesh ssid on page 254• set service-profile mesh on page 320• show ap mesh-links on page 357set ap boot-configuration mesh psk-phraseSpecifies a preshared key (PSK) phrase that a Mesh AP uses for authentication to its Mesh Portal AP.Syntax set ap ap-number boot-configuration mesh psk-phrase passphraseDefaults None.Access Enabled.History Introduced in WSS Version 6.0.ap ap-number Index value that identifies the AP on the WSS.mode {enable | disable} Enables or disables WLAN mesh services for the AP.ap ap-number Index value that identifies the AP on the WSS.passphrase An ASCII string from 8 to 63 characters long. The string cancontain blanks if you use quotation marks at the beginningand end of the string.
