68C3 Connector/Pin-Out Information68C3 Operations Manual North Atlantic Industries, Inc. 12/19/2014Rev: 2014-12-19-0947 www.naii.com Page 308 of 3301JP1(factory use)Slot3Slot2Slot1LED 1GRN - Config OKAMB - AccessRED - BIT StatusUSBMiniB - “J” Type(factory use)J2 (Bottom)22442311234422J1 (Top)P0P1P2JP9 (factory use)JP10 GEO Addr1JP4 (factory use)1JP10: GEO AddrInstall jumper (2mm) to enablechassis Geographical AddressingFront Panel (J1, J2) (Connector Placement and Orientation):Front Panel LEDs [normal operation]** Illuminated** ** Extinguished **GRN [Module(s) config OK] Module(s) config FailYEL [Card Access] [No Card Access]12244232312244J2NOTE:The RED LED on power-up does not necessarily indicate any fault.The RED BIT LED is an ‘OR’ function indicator of all module BIT status registers –certain modules (i.e. D/S simulation) may require initialized conditions, signal inputsand/or reading of the status register to ‘unlatch’ and ‘clear’ before this LED willextinguish after card ‘power-on’.
