68C3 Connector/Pin-Out Information68C3 Operations Manual North Atlantic Industries, Inc. 12/19/2014Rev: 2014-12-19-0947 www.naii.com Page 311 of 3301JP1(factory use)Slot3Slot2Slot1LED 1GRN - Config OKAMB - AccessRED - BIT StatusUSBMiniB - “J” Type(factory use)J2 (Bottom)22442311234422J1 (Top)P0P1P2JP9 (factory use)JP10 GEO Addr1JP4 (factory use)1JP10: GEO AddrInstall jumper (2mm) to enablechassis Geographical AddressingRear I/O Data/Control Planes (P1 Continued):VPXData PlaneP1 Row Row Row Row Row Row RowA B C D E F G1PCIe / SRIORx0+PCIe / SRIORx0- GNDPCIe / SRIOTx0+PCIe / SRIOTx0- GND N/C2 GND User Defined User Defined GND User Defined User Defined GND3 User Defined User Defined GND User Defined User Defined GND N/C4 GND User Defined User Defined GND User Defined User Defined GND5 User Defined User Defined GND User Defined User Defined GND N/C6 GND User Defined User Defined GND User Defined User Defined GND7 User Defined User Defined GND User Defined User Defined GND N/C8 GND User Defined User Defined GND User Defined User Defined GND9 User Defined User Defined GND User Defined User Defined GND User Defined10 GND User Defined User Defined GND User Defined User Defined GND11 User Defined User Defined GND User Defined User Defined GND User Defined12 GND User Defined User Defined GND User Defined User Defined GND13 ETH2-TP0+ ETH2-TP0- GND ETH2-TP1+ ETH2-TP1- GND N/C14 GND ETH2-TP2+ ETH2-TP2- GND ETH2-TP3+ ETH2-TP3- GND15 ETH1-TP0+ ETH1-TP0- GND ETH1-TP1+ ETH1-TP1- GND N/C16 GND ETH1-TP2+ ETH1-TP2- GND ETH1-TP3+ ETH1-TP3- GNDUSER I/O – Defined Area (User Defined I/O) (P3-P6):The following pages contain the ‘user defined’ I/O data area front and rear panel pin-outs with their respectivesignal designations for all module types currently offered/configured for the 68C3 platform. The card is designedto route the function module I/O signals to the front and rear I/O connector. The following I/O connector pin-out isbased upon the function module designated in the particular module slot.
