Chapter 1OverviewI - 20 Electrical Characteristics1.5.3 DC CharacteristicsDC Characteristics (Upper:M-ROM, Lower:Flash)V1 = VDD or V SSOutput openV SS, PV SS = 0.0 VParameter Symbol ConditionsLimitsUnitTyp. Max.C1 Operating supply current(V DD pin)j IDDmVDD = 5.0 VInternal regulator used.FOSC = 10 MHz ( 6 multiplication)Operating circuitryAD0, 1, 2: Continuously convert multiple channels60* 1 90*1mAPWM0, 1: Output triangular waveTimer 0 to 17: Free runningSerial I/F 0 to 2: Send data through synchronoustransmission.Other ports: Product H, L toggle output80* 2 120* 2* 1 MN103SA7D/A7G* 2 MN103SFA7KVDD = 5.0 VV SS = 0.0 VTa = - 40 °C to +85 °CParameter Symbol ConditionsLimitsUnitMin. Typ. Max.I/O pinP10 to P14, P16, P17, P20 to P27, P31 to P37, P42, P43, P46, P47, P51 to P57, P62 to P67, P72, P73, P80 to P83, P90 to P97,PA0 to PA7C2 Input voltage High level VIH1 - VDD x 0.8 - VDD VC3 Input voltage Low level VIL1 - 0.0 - V DD x 0.2 VC4 Input current Low level I IH1VIN=0 VPull-up resistor is used -55 -166 -500 μAC5 Output voltage High levelV OH11 I O = -2 mA V DD - 0.3 - - VVOH12 I O = -4 mA V DD - 0.6 - - VC6 Output voltage Low levelVOL11 I O = 2 mA - - 0.3 VVOL12 I O = 4 mA - - 0.4 VC7 Output leak current I OZ1 V0=Hi-Z status -10 - 10 μAValue of Internal pull-up resistorThe standard value of internal pull-up resistor is 30 kΩ when V DD= 5 V and VIN= 0 V.However, this value may change greatly depending on temperature. In the range from -40 °C to +85 °C,.the value may be 10 kΩ to 91 kΩ.
