February, 20082-123WorkCentre 5225, 5230 012-152Status Indicator RapsLaunch Version012-152 Compile Exit Sensor On JAM RAPBSD-ON:12.16After the H-Transport Exit Sensor turned On, the Compile Exit Sensor did not turn On withinthe specified time.Initial Actions• Power OFF/ONProcedureCheck the Transport Roll for wear and paper powder. The Transport Roll is ok.Y NReplace the Transport Roll.Check for foreign substances, distortion and paper powder in the paper transport path. Nodistortion, foreign substances, or paper powder are found in the paper transport path.Y NClear away the foreign substances and paper powder. Correct the distortion.Execute Component Control[012-150 Compile Exit Sensor]. Actuate the Compile Exit Sensorwith paper. The display changes.Y NCheck the connections of J8869 and P/J8988. J8869 and P/J8988 are connected cor-rectly.Y NConnect J8869 and P/J8988.Check the wire between J8869 and J8988 for an open circuit or a short circuit (BSD12.16). The wire between J8869 and J8988 is conducting without an open circuit ora short circuit.Y NRepair the open circuit or short circuit.Measure the voltage between the Finisher PWB P8988-6 (+) and GND (-) (BSD 12.16).The voltage is approx. +5VDC.Y NReplace the Finisher PWB (PL 23.16).Measure the voltage between the Finisher PWB P8988-5 (+) and GND (-) (BSD 12.16).Actuate the Compile Entrance Sensor with paper. The voltage changes.Y NReplace the Compile Entrance Sensor (PL 23.14).Replace the Finisher PWB (PL 23.16).Execute Component Control[012-038 Transport Motor ON]. The Transport Motor can beheard.Y NCheck the connections of P/J8879 and P/J8983. P/J8879 and P/J8983 are con-nected correctly.Y NConnect P/J8879 and P/J8983.Check the wire between J8879 and J8983 for an open circuit or a short circuit (BSD12.16). The wire between J8879 and J8983 is conducting without an open circuit ora short circuit.Y NRepair the open circuit or short circuit.Measure the resistance of the Transport Motor (PL 23.13) wires between each point ofJ8879-1/2/5/6 (BSD 12.16). The resistance is approx. 20Ohm.Y NReplace the Transport Motor (PL 23.13).Measure the voltage between each point of the Finisher PWB (PL 23.16) P8983-9/10/11/12 (+) and GND (-) (BSD 12.16). The voltage is approx. +24VDC.Y NReplace the Finisher PWB (PL 23.16).Replace the Transport Motor (PL 23.13). If the problem persists, replace the FinisherPWB (PL 23.16).Replace the Finisher PWB (PL 23.16).AA
