February, 20082-547WorkCentre 5225, 5230 077-109Status Indicator RapsLaunch Version077-109 IOT Exit Sensor ON JAM Straight RAPBSD-ON:10.3/10.4After the Fuser Exit Sensor turned On, the Exit 2 Sensor did not turn On within the specifiedtime.Initial Actions• Power OFF/ONProcedureCheck the installation of the Exit 2 Module. The Exit 2 Module is installed correctly.Y NInstall the Exit 2 Module correctly.Check the Transport Roll for wear and paper powder. The Transport Roll is ok.Y NReplace the Transport Roll.Check for foreign substances, distortion and paper powder in the paper transport path. Nodistortion, foreign substances, or paper powder are found in the paper transport path.Y NClear away the foreign substances and paper powder. Correct the distortion.Open Left Upper Cover Assembly and verify that Exit 1 Gate (PL 6.2) is free to move. Exit 1Gate is free to move.Y NRepair as required.Check the clearance between the Diverter Gate and the Fixed Guide on the left hand door. PL6.4- PL 6.5). Operation is satisfactory.Y NRepair as required (PL 6.4 - PL 6.5).Execute Component Control [071-110 Exit 2 Sensor]. Actuate the Exit 2 Sensor (PL 6.4) withpaper. The display changes to H.Y NCheck the wire between P/J112 and P/J434 for an open circuit or a short circuit (BSD10.3 Flag 1/Flag 2). The wire between J112 and J434 is conducting without an opencircuit or a short circuit.Y NRepair the open circuit or short circuit.Replace the Exit 2 Sensor (PL 6.4). If the problem persists, replace the Exit PWB (PL9.1).Execute Component Control [047-023 Exit 2 Motor ON]. The Exit 2 Motor (PL 6.4) can beheard.Y NCheck the wire between P/J208 and P/J433 for an open circuit or a short circuit (BSD10.4 Flag 1). The wire between J208 and J433 is conducting without an open circuitor a short circuit.Y NRepair the open circuit or short circuit.Measure the resistance of the Exit 2 Motor (PL 6.4) between J208-1 and each point ofJ208-2/3/4/5 (BSD 10.4 Flag 2). The resistance is approx. 10Ohm.Y NReplace the Exit 2 Motor (PL 6.4).Replace the Exit 2 Motor (PL 6.4). If the problem persists, replace the Exit PWB (PL 9.1).Execute Component Control [047-024 Exit Gate Solenoid ON]. The Exit Gate Solenoid (PL6.4) starts up and the gates start switching.Y NCheck the wire between P/J209 and P/J433 for an open circuit or a short circuit (BSD10.4 Flag 3). The wire between J209 and J433 is conducting without an open circuitor a short circuit.Y NRepair the open circuit or short circuit.Measure the resistance of the Exit Gate Solenoid (PL 6.4) between J209-1 and J209-2(BSD 10.4 Flag 4). The resistance is approx. 160Ohm.Y NReplace the Exit 2 Motor (PL 6.4).Replace the Exit Gate Solenoid (PL 6.4). If the problem persists, replace the Exit PWB(PL 9.1).Replace the Exit PWB (PL 9.1).AA
