February, 20082-367WorkCentre 5225, 5230 024-985 , 024-989Status Indicator RapsLaunch Version024-985 MPT Feed Failure RAPThe job was aborted during MPT feed.Initial Actions• Refer to BSD 7.13.• Check the operation of the MPT Guide.ProcedureCheck the document size. The size of the document is within the specification.Y NUse a paper size within the specification.Check for foreign substances, distortion and paper powder in the paper transport path. Nodistortion, foreign substances, or paper powder are found in the paper transport path.Y NClear away the foreign substances and paper powder. Correct the distortion.Check the installation and operation of the MPT Guide. The MPT Guide is installed correctlyand the actuator works.Y NReinstall the MPT GuideMeasure the voltage between the MCU PWB P411-3 (+) and GND (-) (BSD 7.13 Flag 1).Manually operate the MPT Guide. As the MPT Guide moves, the voltage changes accord-ingly.Y NCheck the connections of P/J107, P/J609, P/J605 and P/J411. P/J107, P/J609, P/J605 and P/J411 are connected correctly.Y NConnect P/J107, P/J609, P/J605 and P/J411.Check the wire between J107 and J411 for an open circuit or a short circuit (BSD 7.13Flag 1/Flag 2). The wire between J107 and J411 is conducting without an open cir-cuit or a short circuit.Y NRepair the open circuit or short circuit.Measure the voltage between the MCU PWB P411-1 (+) and GND (-) (BSD 7.13 Flag 2).The voltage is approx. +5VDC.Y NReplace the MCU PWB (PL 9.1).Replace the MPT Paper Size Sensor (PL 7.3).Replace the MCU PWB (PL 9.1).024-989 Booklet Low StapleBooklet Maker Stapler Low Staple signal is detected to be on at Staple operations.Initial ActionsCheck staples, set properly or add more staples.ProcedureIf failure continues check the proper operation of the Front or Rear Low Staple Switch. (BSD12.26, BSD 12.27)
