February, 20082-124 WorkCentre 5225, 5230012-161Launch VersionStatus Indicator Raps012-161 Finisher Set Eject JAM RAPBSD-ON:12.19/12.22After the Eject Motor turned On, the Compile No Paper Sensor did not turn Off within the spec-ified time.Initial Actions• Power OFF/ONProcedureExecute Component Control[012-151 Compile No Paper Sensor]. Actuate the Compile NoPaper Sensor with paper. The display changes.Y NCheck the connections of J8880 and J8984. J8880 and J8984 are connected cor-rectly.Y NConnect J8880 and J8984.Check the wire between J8880 and J8984 for an open circuit or a short circuit (BSD12.19). The wire between J8880 and J8984 is conducting without an open circuit ora short circuit.Y NRepair the open circuit or short circuit.Measure the voltage between the Finisher PWB P8984-3 (+) and GND (-) (BSD 12.19).The voltage is approx. +5VDC.Y NReplace the Finisher PWB (PL 23.16).Measure the voltage between the Finisher PWB P8984-2 (+) and GND (-) (BSD 12.19).Actuate the Compile Paper Sensor with paper. The voltage changes.Y NReplace the Compile Paper Sensor (PL 23.12).Replace the Finisher PWB (PL 23.16).Alternately execute Component Control[012-054 Eject Motor FORWARD LO] and ComponentControl[012-055 Eject Motor FORWARD HI]. The Eject Motor starts up.Y NCheck the connections of P/J8878 and P/J8983. P/J8878 and P/J8983 are con-nected correctly.Y NConnect P/J8878 and P/J8983.Check the wire between J8878 and J8983 for an open circuit or a short circuit (BSD12.22). The wire between J8878 and J8983 is conducting without an open circuit ora short circuit.Y NRepair the open circuit or short circuit.Measure the resistance of the Eject Motor between each point of J8878-1/3/4/6 (BSD12.22). The resistance is approx. 2Ohm.Y NReplace the Eject Motor (PL 23.11).Measure the voltage between the Finisher PWB (PL 23.16) J8983-5/6/7/8 (+) and GND (-), and between P8846-12 (+) and GND (-) (BSD 12.22). The voltage is approx.+24VDC.Y NReplace the Finisher PWB (PL 23.16).Replace the Eject Motor (PL 23.11). If the problem persists, replace the Finisher PWB (PL23.16).Replace the Finisher PWB (PL 23.16).AABB
