February, 20082-65WorkCentre 5225, 5230 005-145Status Indicator RapsLaunch Version005-145 CVT Registration Sensor Off JAM (Invert) RAPAfter the DADF Pre Registration Sensor turned Off at Invert, the Registration Sensor did notturn Off within the specified time.Initial ActionsRefer to BSD 5.4/5.5.Open the DADF Top Cover and remove the paper.ProcedureExecute Component Control[005-110]. Actuate the DADF Registration Sensor (PL 15.7) withpaper. The display changes.Y NCheck the connections of P/J782 and P/J761. P/J782 and P/J761 are connected cor-rectly.Y NConnect P/J782 and P/J761.Check the wire between J782 and J761 for an open circuit or a short circuit (BSD 5.4 Flag1/Flag 2). The wire between J782 and J761 is conducting without an open circuit ora short circuit.Y NRepair the open circuit or short circuit.Measure the voltage between the DADF PWB P761-15 (+) and GND (-) (BSD 5.4 Flag2). The voltage is approx. +5VDC.Y NReplace the DADF PWB (PL 15.3).Measure the voltage between the DADF PWB P761-14 (+) and GND (-) (BSD 5.4 Flag1). Actuate the DADF Registration Sensor with paper. The voltage changes.Y NReplace the DADF Registration Sensor (PL 15.7).Replace the DADF PWB (PL 15.3).Execute Component Control[005-001]. The DADF Feed Motor (PL 15.9) starts up.Y NCheck the connections of P/J764 and P/J754. P/J764 and P/J754 are connected cor-rectly.Y NConnect P/J764 and P/J754.Check the wire between J764 and J754 for an open circuit or a short circuit (BSD 5.5 Flag1). The wire between J764 and J754 is conducting without an open circuit or a shortcircuit.Y NRepair the open circuit or short circuit.Measure the voltage between the DADF PWB (PL 15.3) P754-1 (+) and GND (-), andbetween P754-7 (+) and GND (-) (BSD 5.5 Flag 1). The voltage is approx. +24VDC.Y NReplace the DADF PWB (PL 15.3).Replace the DADF Feed Motor (PL 15.9). If the problem persists, replace the DADF PWB(PL 15.3).Execute Component Control[005-026]. The DADF Registration Motor (PL 15.9) starts up.Y NCheck the connections of P/J765 and P/J755. P/J765 and P/J755 are connected cor-rectly.Y NConnect P/J765 and P/J755.Check the wire between J765 and J755 for an open circuit or a short circuit (BSD 5.5 Flag2). The wire between J765 and J755 is conducting without an open circuit or a shortcircuit.Y NRepair the open circuit or short circuit.Measure the voltage between the DADF PWB (PL 15.3) P755-1 (+) and GND (-), andbetween P755-6 (+) and GND (-) (BSD 5.5 Flag 2). The voltage is approx. +24VDC.Y NReplace the DADF PWB (PL 15.3).Replace the DADF Registration Motor (PL 15.9). If the problem persists, replace theDADF PWB (PL 15.3).Replace the DADF PWB (PL 15.3).AABB
