February, 20082-63WorkCentre 5225, 5230 005-136Status Indicator RapsLaunch Version005-136 CVT Side2 Registration On JAM RAPAfter the DADF Pre Registration Sensor turned On at Invert, the DADF Registration Sensor didnot turn On within the specified time.Initial Actions• Refer to BSD 5.4.ProcedureExecute Component Control[005-110]. Actuate the DADF Registration Sensor (PL 15.7) withpaper. The display changes.Y NCheck the connections of P/J782 and P/J761 P/J782 and P/J761 are connected cor-rectly.Y NConnect P/J782 and P/J761.Check the wire between J782 and J761 for an open circuit or a short circuit (BSD 5.4 Flag1/Flag 2). The wire between J782 and J761 is conducting without an open circuit ora short circuit.Y NRepair the open circuit or short circuit.Measure the voltage between the DADF PWB P761-15 (+) and GND (-) (BSD 5.5 Flag2). The voltage is approx. +5VDC.Y NReplace the DADF PWB (PL 15.3).Measure the voltage between the DADF PWB P761-14 (+) and GND (-) (BSD 5.5 Flag 1).Actuate the DADF Registration Sensor with paper. The voltage changes.Y NReplace the DADF Registration Sensor (PL 15.7).Replace the DADF PWB (PL 15.3).Execute Component Control[005-001]. The DADF Feed Motor (PL 15.9) starts up.Y NCheck the connections of P/J764 and P/J754. P/J764 and P/J754 are connected cor-rectly.Y NConnect P/J764 and P/J754.Check the wire between J764 andJ754 for an open circuit or a short circuit (BSD 5.5 Flag1). The wire between J764 and J754 is conducting without an open circuit or a shortcircuit.Y NRepair the open circuit or short circuit.Measure the voltage between the DADF PWB (PL 15.3) P754-1 (+) and GND (-), andbetween P754-7 (+) and GND (-) (BSD 5.5 Flag 1). The voltage is approx. +24VDC.Y NReplace the DADF PWB (PL 15.3).Replace the DADF Feed Motor (PL 15.9). If the problem persists, replace the DADF PWB(PL 15.3).Execute Component Control[005-072]. The Exit Nip Release Solenoid (PL 15.7) can beheard.Y NCheck the connections of P/J766 and P/J756. P/J766 and P/J756 are connected cor-rectly.Y NConnect P/J766 and P/J756.Check the wire between P756 and J766 for an open circuit or a short circuit (BSD 5.6 Flag2). The wire between P756 and J766 is conducting without an open circuit or ashort circuit.Y NRepair the open circuit or short circuit.Replace the Exit Nip Release Solenoid (PL 15.7). If the problem persists, replace theDADF PWB (PL 15.3).Replace the DADF PWB (PL 15.3).AABB
