February, 20082-135WorkCentre 5225, 5230 012-260, 012-263Status Indicator RapsLaunch VersionCheck the wire between J8878 and J8983 for an open circuit or a short circuit (BSD12.22). The wire between J8878 and J8983 is conducting without an open circuit ora short circuit.Y NRepair the open circuit or short circuit.Measure the resistance of the Eject Motor (PL 22.9) between each point of J8878-1/3/4/6(BSD 12.22). The resistance is approx. 2Ohm.Y NReplace the Eject Motor (PL 22.9).Measure the voltage between the Finisher PWB (PL 23.16) P8983-5/6/7/8 (+) and GND (-) (BSD 12.22). The voltage is approx. +24VDC.Y NReplace the Finisher PWB (PL 23.16).Replace the Eject Motor (PL 22.9). If the problem persists, replace the Finisher PWB (PL23.16).Replace the Finisher PWB (PL 23.16).012-263 Rear Tamper Failure RAPBSD-ON:12.19After the Rear Tamper started moving to the home position, the Rear Tamper Home Sensor didnot turn On within 800ms.Initial ActionsPower OFF/ONRemove foreign substances in the Compiler Tray.ProcedureManually operate the Tamper mechanism. The Tamper mechanism moves smoothly.Y NReplace the parts that are interfering with operation.Execute Component Control[012-221 Rear Tamper Home Sensor]. Actuate the Rear TamperHome Sensor with paper. The display changes.Y NCheck the connections of J8882 and J8984. J8882 and J8984 are connected cor-rectly.Y NConnect J8882 and J8984.Check the wire between J8882 and J8984 for an open circuit or a short circuit (BSD 12.The wire between J8882 and J8984 is conducting without an open circuit or a shortcircuit.Y NRepair the open circuit or short circuit.Measure the voltage between the Finisher PWB P8984-9 (+) and GND (-) (BSD 12.19).The voltage is approx. +5VDC.Y NReplace the Finisher PWB (PL 23.16).Measure the voltage between the Finisher PWB P8984-8 (+) and GND (-) (BSD 12.19).Actuate the Rear Tamper Home Sensor with paper. The voltage changes.Y NReplace the Rear Tamper Home Sensor (PL 23.12).Replace the Finisher PWB (PL 23.16).Alternately execute Component Control[012-026 Rear Tamper Motor FRONT ON] and Compo-nent Control[012-029 Rear Tamper Motor REAR ON]. The Rear Tamper Motor starts up.Y NCheck the connections of P/J8883 and J8984. P/J8883 and J8984 are connectedcorrectly.Y NConnect P/J8883 and J8984.A BA B
