February, 20082-363WorkCentre 5225, 5230 024-977, 024-978Status Indicator RapsLaunch Version024-977 Stapler Feed Ready Failure RAPWhen starting Staple, Staple Ready Sensor Off was detected.Empty stapling was within 13 times.Initial ActionsRefer to BSD 12.6.Reload the Staple Cartridge.ProcedureExecute Component Control[012-243]. Install and remove the Staple Cartridge. The displaychanges.Y NCheck the Staple Cartridge for failure or foreign substances. There are no foreign sub-stances and nothing has failed.Y NRepair the failure and remove the foreign substances.Check the connections of P/J8818 and P/J8852. P/J8818 and P/J8852 are connectedcorrectly.Y NConnect P/J8818 and P/J8852.Check the wire between J8818 and J8852 for an open circuit or a short circuit (BSD12.6). The wire between J8818 and J8852 is conducting without an open circuit or ashort circuit.Y NRepair the open circuit or short circuit.Measure the voltage between the Finisher PWB P8852-1 (+) and GND (-) (BSD 12.6).The voltage is approx. +5VDC.Y NReplace the Finisher PWB (PL 22.7).Measure the voltage between the Finisher PWB P8852-3 (+) and GND (-) (BSD 12.6).Install and remove the Staple Cartridge. The voltage changes.Y NReplace the Finisher PWB (PL 22.7).Replace the Staple Assembly (PL 22.4). If the problem persists, replace the Finisher PWB(PL 22.7).Replace the Finisher PWB (PL 22.7). If the problem persists, replace the MCU PWB (PL 9.1).024-978 Booklet Stapler FaultBooklet Maker Stapler not ready.Initial ActionsCheck staples, reset the stapler cartridge.ProcedureCheck for proper operation of the Booklet Stapler Cover Switch, and the Stapler Front SafetySwitches. (BSD 12.13)
