February, 20082-561WorkCentre 5225, 5230 078-500 , 078-900Status Indicator RapsLaunch Version078-500 Write to HCF-ROM error detection (During DLDmethod) RAPAn error has occurred during the process of writing data to the HCF-ROM. (During DLD method)ProcedureRetry job. If retry failed, replace the HCF-ROM and perform VerUP operation on the DLD methodagain.078-900 HCF Feed Out Sensor Static Jam RAPBSD-ON: 8.9The tray 6 Feed Out Sensor static jam.Initial Actions• Clear any jam and switch the power off then on.• Check for out-of-spec paper.• Paper Path for a foreign object/burr/piece of paperProcedureExecute Component Control [078-101 Tray 6 Feed Out Sensor]. Move the actuator of the Tray6 Feed Out Sensor. The display changes.Y NGo to 8.8 BSD and check the following for an open wire, short or poor contact:• Tray 6 Feed Out Sensor PF67-2 to HCF PWB PF01-2• Tray 6 Feed Out Sensor PF67-1 to HCF PWB PF01-3• Tray 6 Feed Out Sensor PF67-3 to HCF PWB PF01-1If OK, replace the Tray 6 Feed Out Sensor (PL 18.7) then the HCF PWB (PL 18.8).Execute Component Control [078-007 Tray 6 Takeaway Motor: 640mm/s]. There is opera-tion noise from the Tray 6 Takeaway Motor.Y NCheck the wire-wound resistance of Pre Reg. Motor is approx. 0.8 ohms at the measurementpoints below.• JF57-3 to pins 1/2• JF57-4 to pins 5/6If OK, go to 7.14 BSD and troubleshoot the Tray 6 Takeaway Motor circuit.Execute Component Control [089-002 REgistration Clutch. Registration Clutch operatesY NGo to 8.7 BSD and check the Registration Clutch for an open.Check the following:• Drive gears for wear/breakage• HCF and IOT for a poor docking• HCF Transport Belt for poor tension• HCF Transport Roll for dirt/paper particles/wear/a poor rotation• HCF Takeaway Rolls 1-3 for dirt/ paper particles/wear/a poor rotation• HCF Exit Roll for dirt/ paper particles/wear/a poor rotation• If the results of the above checks are OK, replace HCF PWB (PL1.8).
