February, 20082-490 WorkCentre 5225, 5230035-745, 035-746Launch VersionStatus Indicator Raps035-745 Fax Protocol RAPBSD-ON:16.1/17.1The receiving Fax does not support the SEP (Separator) function.ProcedureThere is a problem with the receiving Fax. Ask customer to cancel the job and resend.035-746 Fax Protocol RAPBSD-ON:16.1/17.1The Fax controller detected one of the following:• No DT1 signal before dialing.• A BT1/BT2 signal before dialing.• A CT1 signal before dialing (a state in which PBX is busy).• A CT2 signal before dialing.• No DT1 signal during dialing (This could happen when an outside line was used withoutany signal sending from the PBX).• A BT1/BT2 signal during dialing.• A CT1/CT2 signal during dialing.• No 2nd DT2 signal during dialing.• A BT1/BT2 signal during dialing.• A CT1/CT2 signal during dialing.• No third DT3 signal during dialing.• A BT1/BT2 signal during dialing.• A CT1/CT2 signal during dialing.• A BT1/BT2 signal after dialing.• A CT1/CT2 signal after dialing.• No DT signal from the PBX before dialing.• A BT signal from the PBX before dialing.• A CT signal from the PBX before dialing.• A BT signal from the PBX after dialing.• A CT signal from the PBX after dialing.ProcedureCheck the electrical connections on the FAX PWB (PL 9.2)If the problem persists perform GP 2 Fax Checkout.If the connections are good then there is a problem with the customers PBX (Private BranchExchange) line or the receiving fax.
