February, 20082-543WorkCentre 5225, 5230 077-101Status Indicator RapsLaunch Version077-101 Registration Sensor Off JAM RAPBSD-ON:8.7After the Registration Clutch turned On, the Registration Sensor did not turn Off within thespecified time.Initial Actions• Power OFF/ONProcedureCheck the Transport Roll for wear and paper powder. The Transport Roll is ok.Y NReplace the Transport Roll.Check for foreign substances, distortion and paper powder in the paper transport path. Nodistortion, foreign substances, or paper powder are found in the paper transport path.Y NClear away the foreign substances and paper powder. Correct the distortion.Execute Component Control [089-100 Registration Sensor]. Manually activate the actuator ofthe Registration Sensor (PL 2.4). The display changes.Y NCheck the connection of P/J104 and P/J403. P/J104 and P/J403 are connected cor-rectly.Y NConnect P/J104 and P/J403.Check the wire between J104 and J403 for an open circuit or a short circuit (BSD 8.7 Flag1/Flag 2). The wire between J104 and J403 is conducting without an open circuit ora short circuit.Y NRepair the open circuit or short circuit.Measure the voltage between the MCU PWB P403B-13 (+) and GND (-) (BSD 8.7 Flag2). The voltage is approx. +5VDC.Y NReplace the MCU PWB (PL 9.1).Measure the voltage between the MCU PWB P403B-8 (+) and GND (-) (BSD 8.7 Flag 1).Actuate the Registration Sensor with paper. The voltage changes.Y NReplace the Registration Sensor (PL 2.4).Replace the MCU PWB (PL 9.1).Execute Component Control [089-002 Registration Clutch ON]. The Registration Clutch (PL2.4) can be heard.Y NCheck the connection of P/J215 and P/J403. P/J215 and P/J403 are connected cor-rectly.Y NConnect P/J215 and P/J403.Measure the resistance of the Registration Clutch (PL 2.4) between P215-1 and P215-2(BSD 8.7 Flag 3). The resistance is approx. 240Ohm.Y NReplace the Registration Clutch (PL 2.4).Check the wire between J215 and J403 for an open circuit or a short circuit (BSD 8.7 Flag3). The wire between J215 and J403 is conducting without an open circuit or a shortcircuit.Y NRepair the open circuit or short circuit.Replace the MCU PWB (PL 9.1).Replace the MCU PWB (PL 9.1).AA
