February, 20082-151WorkCentre 5225, 5230 012-923, 012-935Status Indicator RapsLaunch Version012-923 H-Transport Entrance SNR static JAM B RAPBSD-ON:12.14During standby, paper was detected by the H-Transport Entrance Sensor.Initial ActionsRemove foreign substances on the sensor.Power OFF/ONProcedureExecute Component Control[012-190 H-Transport Entrance Sensor]. Actuate the H-TransportEntrance Sensor (PL 23.4) with paper. The display changes.Y NCheck the connections of J8861 and J8987. J8861 and J8987 are connected cor-rectly.Y NConnect J8861 and J8987.Check the wire between J8861 and J8987 for an open circuit or a short circuit (BSD12.14). The wire between J8861 and J8987 is conducting without an open circuit ora short circuit.Y NRepair the open circuit or short circuit.Measure the voltage between the Finisher PWB P8987-4 (+) and GND (-) (BSD 12.14).The voltage is approx. +5VDC.Y NReplace the Finisher PWB (PL 23.16).Measure the voltage between the Finisher PWB P8987-6 (+) and GND (-) (BSD 12.14).Actuate the H-Transport Entrance Sensor with paper. The voltage changes.Y NReplace the H-Transport Entrance Sensor (PL 23.4).Replace the Finisher PWB (PL 23.16).Replace the Finisher PWB (PL 23.16).012-935 Paper at Xport Entrance SensorBSD-ON:12.16Control logic reports paper at the Xport Entrance Sensor.Initial Actions• Check for obstructions in the paper path• Check that the Finisher is dock correctly to ensure proper Transport Gate operationProcedureEnter Component Control [012-100], Finisher Entrance Sensor. Select Start. Actuate the Fin-isher Entrance Sensor. The display changes.Y NCheck the connections of J8869 and P/J8988. J8869 and P/J8988 are connectedcorrectly.Y NConnect J8869 and P/J8988.Check the wire between J8861 and J8988 for an open circuit or a short circuit (BSD12.14). The wire between J8861 and J8988 is conducting without an open circuit ora short circuit.Y NRepair the open circuit or short circuit.Measure the voltage between the Finisher PWB P8988-6 (+) and GND (-) (BSD 12.16).The voltage is approx. +5VDC.Y NReplace the Finisher PWB (PL 23.16).Measure the voltage between the Finisher PWB P8988-5 (+) and GND (-) (BSD 12.16).Actuate the Finisher Entrance Sensor with paper. The voltage changes.Y NReplace the Finisher Entrance Sensor (PL 23.4).Replace the Finisher PWB (PL 23.16).Replace the Finisher PWB (PL 23.16).
