February, 20082-362 WorkCentre 5225, 5230024-975, 024-976Launch VersionStatus Indicator Raps024-975 Copy Booklet Sheets Counts OverNumber of sheets detected upon start of printing exceeded maximum number sheets allowedfor Booklet maker.Initial ActionsReduce the number of sheets set for Booklet Maker or cancel Booklet Maker job.ProcedureCancel job or reduce number of sheets set for this job.024-976 Finisher Staple Status Failed RAP• After the Stapler Motor turned On (Forward rotation), the system did not detect that theStaple Head Home Sensor switched from Off to On within the specified time.• After the Stapler Motor turned On (Reverse rotation), the Staple Head Home Sensor didnot turn On within the specified time.Initial ActionsRefer to BSD 12.6.ProcedureAlternately execute Component Control[012-046 Staple Motor FORWARD ON] and Compo-nent Control[012-047 Staple Motor REVERSE ON]. The Stapler Motor can be heard.Y NCheck the connections of P/J8819 and P/J8847. P/J8819 and P/J8847 are connectedcorrectly.Y NConnect P/J8819 and P/J8847.Check the wire between J8819 and J8847 for an open circuit or a short circuit (BSD12.6). The wire between J8819 and J8847 is conducting without an open circuit or ashort circuit.Y NRepair the open circuit or short circuit.Replace the Staple Assembly (PL 22.4). If the problem persists, replace the Finisher PWB(PL 22.7).Execute Component Control[012-244 Staple Head Home Sensor]. Alternately execute Com-ponent Control[012-046 Staple Motor FORWARD ON] and Component Control[012-047 StapleMotor REVERSE ON]. The display changes.Y NCheck the connections of P/J8818 and P/J8852. P/J8818 and P/J8852 are connectedcorrectly.Y NConnect P/J8818 and P/J8852.Check the wire between J8818 and J8852 for an open circuit or a short circuit (BSD12.6). The wire between J8818 and J8852 is conducting without an open circuit or ashort circuit.Y NRepair the open circuit or short circuit.Measure the voltage between the Finisher PWB P8852-1 (+) and GND (-) (BSD 12.6).The voltage is approx. +5VDC.Y NReplace the Finisher PWB (PL 22.7).Replace the Staple Assembly (PL 22.4). If the problem persists, replace the Finisher PWB(PL 22.7).Replace the Finisher PWB (PL 22.7). If the problem persists, replace the MCU PWB (PL 9.1).
