February, 2008iv WorkCentre 5225, 5230Launch VersionIntroductionSection 7: Wiring DataThis section contains drawings, lists of plug/jack locations, and diagrams of the power distribu-tion wire networks in the machine. This section also contains the Block Schematic Diagrams.Section 8: Options and AccessoriesThis section contains installation information for option and accessory.How to Use this DocumentationThe Service Call Procedures in Section 1 describe the sequence of activities used during theservice call. The call must be entered using these procedures.Use of the Circuit DiagramsAll wirenets are shown on the Circuit Diagrams (CDs). Power distribution wirenets are shownin Section 7 (Wiring Data) of the Service Manual. The power distribution wirenets on the CDswill end at the terminal board for the power being distributed. Find the wirenet for that powerand locate the terminal board on the wirenet. Use the wirenet to troubleshoot any power distri-bution wiring not shown on the CD.Use of the Block Schematic DiagramsBlock Schematic Diagrams (BSDs) are included in Section 7 (Wiring Data) of the Service Man-ual. The BSDs show the functional relationship of the electrical circuitry to any mechanical, ornon-mechanical, inputs or outputs throughout the machine. Inputs and outputs such as motordrive, mechanical linkages, operator actions, and air flow are shown. The BSDs will provide anoverall view of how the entire subsystem works.It should be noted that the BSDs no longer contain an Input Power Block referring to Chain 1. Itwill be necessary to refer to the Wirenets in order to trace a wire back to its source.
