February, 20082-568 WorkCentre 5225, 5230091-910, 091-911Launch VersionStatus Indicator Raps091-910 Waste Toner Bottle Position RAPBSD-ON:9.9The Waste Toner Bottle is not in the correct position.ProcedureCheck the installation of the Waste Toner Bottle. Waste Toner Bottle installation is correct.Y NCorrect the installation problem by checking for damaged mounting points.Verify the condition of the circuit, BSD9.9, between the Waste Toner Position Sensor and MCUPWB. The circuit is free of damage.Y NRepair the circuit as required.Ensure the Waste Toner Bottle is installed correctly. Then check Waste Toner Bottle sensor operat-ing voltage and output. The signal level voltage indicates the Waste Toner Bottle is cor-rectly installed.Y NThere is a problem with the sensor. Repair or replace the Waste Toner Position Sensor(PL 4.2).Replace the MCU PWB (PL 9.1).091-911 Waste Toner Full RAPBSD-ON:9.9The Waste Toner Bottle is full.ProcedureCheck the contents level of the Waste Toner Bottle. The Waste Toner Bottle is full.Y NVerify the condition of the circuit, BSD9.9, between the Waste Toner Bottle Sensor and MCUPWB. The circuit is free of damage.Y NRepair the circuit as required.Ensure the Waste Toner Bottle is installed correctly. Then check Waste Toner Bottle Full Sen-sor operating voltage and output. The signal level voltage indicates the Waste TonerBottle is full.Y NReplace the MCU PWB (PL 9.1).There is a problem with the sensor. Repair or replace the Waste Toner Full Sensor (PL4.2).Replace the Waste Toner Bottle. If the problem persists, return to the beginning of the RAP.
