February, 20082-692 WorkCentre 5225, 5230124-706, 124-708Launch VersionStatus Indicator Raps124-706 Folding Cancelled RAPFold request is canceled to continue printing.ProcedureAsk customer to check the job setup.124-708 Output Tray Changed to Sub Tray RAPOutput destination is changed to Sub Tray to continue printing.ProcedurePaper is output to Center Tray instead of designated tray.(1) Paper of different size from paper size designated with duplex designation is fed.(2) Puncher of Finisher C has failure.[(1)Output to Sub Tray at size mismatch occurrence in duplex designation]-When size mismatch occurs, paper is output to the designated tray while Simplex is designatedand to Sub Tray while Duplex is designated.-On the control panel, message saying that output destination is changed to Sub Tray is displayedwhen Sheet Delivered is received from IOT, with the message, “Copying in progress” displayedafter Start button is pressed, until IOT is stopped.-No display on the driver.[(2) Output to Sub Tray at the occurrence of Finisher failure]-Decurler failure and Puncher failure shall be handled not as SubSystemFail but as LocalFail.-When Decurler failure occurs, paper is output to designated Finisher.-When Puncher failure occurs, paper is output to Sub Tray.-When Booklet is designated, however, paper is output to Booklet.-On the control panel, message saying that output destination is changed to Sub Tray is displayedwhen SheetDelivered is received from IOT, with the message, “Copying in progress” displayedafterStart button is pressed, until IOT is stopped.
