February, 20082-136 WorkCentre 5225, 5230012-263, 012-265Launch VersionStatus Indicator RapsCheck the wire between J8883 and J8984 for an open circuit or a short circuit (BSD12.18). The wire between J8883 and J8984 is conducting without an open circuit ora short circuit.Y NRepair the open circuit or short circuit.Measure the resistance of the Front Tamper Motor between J8984-19 and each point ofJ8984-1/3/4/6 (BSD 12.18). The resistance is approx. 750Ohm.Y NReplace the Front Tamper Motor (PL 23.12).Measure the voltage between the Finisher PWB J8984-19 and each point of J8984-1/3/4/6 (BSD 12.18). The voltage is approx. +24VDC.Y NReplace the Finisher PWB (PL 23.16).Replace the Front Tamper Motor (PL 23.12). If the problem persists, replace the FinisherPWB (PL 23.16).Replace the Finisher PWB (PL 23.16).012-265 Booklet Folder Home Sensor OFF FailWhen the Booklet Home moves from Home position, the Folder Home Sensor did not turn OFFwithin the specified time.Initial Actions• The Folder Home Sensor for improper installation• The Folder Home Sensor connectors for connection failure• The Booklet Fold Knife Motor connectors for connection failure• The Knife drive mechanism for a foreign substanceProcedureManually move the Booklet Tamper to both ends. Enter Component Control [013-022, FolderKnife Motor FWD] and [013-023, Folder Knife Motor REV] alternately. Select Start. TheBooklet Folder Roll Motor energizes.Y NSelect Stop. Check continuity between the Booklet Folder Knife Motor and the BookletPWB and between the Booklet PWB and the Finisher PWB. The continuity check isOK.Y NRepair the open circuit or short circuit.Replace the Booklet Folder Knife Motor (PL 23.15). If the problem continues, replace theBooklet PWB (PL 23.21). If the problem persists, replace Finisher PWB (PL 23.16).Select Stop. Select [13-101, Folder Home Sensor]. Select Start. Block/unblock the FolderHome Sensor. The display changed.Y NSelect Stop. Check continuity between the Folder Home Sensor and the Booklet PWBand between the Booklet PWB and the Finisher PWB. The continuity check is OK.Y NRepair the open circuit or short circuit.Replace the Folder Home Sensor (PL 23.15). If the problem continues, replace the Book-let PWB (PL 23.21). If the problem persists, replace Finisher PWB (PL 23.16).Select Stop. If the problem continues, replace the Finisher PWB (PL 23.16).A B
