February, 20082-352 WorkCentre 5225, 5230024-949, 024-950Launch VersionStatus Indicator Raps024-949 Tray 4 Out Of Place RAPThe Tray 4 Paper Size Switch detected no tray.Initial Actions• Refer to BSD 7.4/7.6.• Reload the tray correctly.• Check the operation of the tray actuator.Procedure[For 2TM]Remove Trays 3 and 4. Replace Tray 3 with Tray 4. [024-949] occurs.Y NReplace the faulty part of the Tray 4 Actuator.Check the installation of the Tray 4 Paper Size Switch. The Tray 4 Paper Size Switch isinstalled correctly.Y NInstall the Tray 4 Paper Size Switch correctly.Go to the BSD 7.4 Tray 4 Paper Size Sensing and check the connectors.[For TTM]Check the Tray 4 Actuator. The Tray 4 Actuator is not distorted.Y NReplace the faulty part of the Tray 4 Actuator.Check the installation of the Tray 4 Paper Size Switch. The Tray 4 Paper Size Switch isinstalled correctly.Y NInstall the Tray 4 Paper Size Switch correctly.Go to the BSD 7.6 Tray 4 Paper Size Sensing and check the connectors.024-950 Tray 1 Empty RAPTray 1 has run out of paper.Initial Actions• Refer to BSD 7.7.ProcedureCheck the installation of the Tray 1 No Paper Sensor (PL 2.3) and the operation of the actua-tor. The Tray 1 Level Sensor is installed correctly and the actuator works.Y NReinstall the Tray 1 Level Sensor.Execute Component Control[071-201 Tray 1 No Paper Sensor]. Manually activate the Tray 1No Paper Sensor (PL 2.3). The display changes.Y NCheck the connections of P/J101, P/J601 and P/J409. P/J101, P/J601 and P/J409are connected correctly.Y NConnect P/J101, P/J601 and P/J409.Check the wire between J101 and J409 for an open circuit or a short circuit (BSD 7.7 Flag4/Flag 5). The wire between J101 and J409 is conducting without an open circuit ora short circuit.Y NRepair the open circuit or short circuit.Measure the voltage between the MCU PWB P409A-10 (+) and GND (-) (BSD 7.7 Flag5). The voltage is approx. +5VDC.Y NReplace the MCU PWB (PL 9.1).Measure the voltage between the MCU PWB P409B-12 (+) and GND (-) (BSD 7.7 Flag4).Activate the actuator of the Tray 1 No Paper Sensor (PL 2.3). The voltage changes.Y NReplace the Tray 1 No Paper Sensor (PL 2.3).Replace the MCU PWB (PL 9.1).Replace the MCU PWB (PL 9.1).
