u E2: Motor 1 ParametersNo.(Addr.Hex) Name Description Values PageE2-01(30E) Motor Rated CurrentSets the motor nameplate full load current in amps. Automatically set duringAuto-Tuning. Default: <1>Min.: 10% of driverated currentMax.: 200% ofdrive rated current<2>195E2-02(30F) Motor Rated SlipSets the motor rated slip. Automatically set during Auto-Tuning. Default: <1>Min.: 0.00 HzMax.: 20.00 Hz195E2-03(310) Motor No-Load CurrentSets the no-load current for the motor. Automatically set during Auto-Tuning. Default: <1>Min.: 0 AMax.: E2-01 <2>196E2-04(311) Number of Motor Poles Sets the number of motor poles. Automatically set during Auto-Tuning. Default: 4Min.: 2Max.: 48 196E2-05(312) Motor Line-to-LineResistanceSets the phase-to-phase motor resistance. Automatically set duringAuto-Tuning. Default: <1>Min.: 0.000 ΩMax.: 65.000 Ω196E2-06(313) Motor Leakage InductanceSets the voltage drop due to motor leakage inductance as a percentage of motorrated voltage. Automatically set during Auto-Tuning. Default: <1>Min.: 0.0%Max.: 40.0%196E2-10(317) Motor Iron Loss for TorqueCompensationSets the motor iron loss. Default: <1>Min.: 0 WMax.: 65535 W196E2-11(318) Motor Rated PowerSets the motor rated power in kilowatts (1 HP = 0.746 kW). Automatically setduring Auto-Tuning. Default: <1>Min.: 0.00 kWMax.: 650.00 kW196<1> Default setting is dependent on parameter o2-04, Drive Model Selection.<2> The number of decimal places in the parameter value depends on the drive model 1. This value has two decimal places (0.01 A) if the drive is setfor a maximum applicable motor capacity up to and including 11 kW, and one decimal place (0.1 A) if the maximum applicable motor capacity ishigher than 11 kW.B.6 E: Motor ParametersYASKAWA SIEP YAIP1U 01C AC Drive - P1000 Technical Manual 447B Parameter List