u S6: P1000 ProtectionNo.(Addr.Hex) Name Description Values PageS6-01(3236) Emergency Override Speed Sets the speed command used in emergency override mode when S6-02 = 0. Default: 0.00 HzMin.: 0.00Max.: 240.00 284S6-02(3237) Emergency OverrideReference SelectionSelects the emergency override speed source.0: Use S6-01 Reference1: Use Frequency ReferenceDefault: 0Range: 0, 1 284S6-07(323C) Output Phase Loss Level forDynamic Noise Control Reduces the output phase loss level when Dynamic Noise Control is active. Default: 100.0%Min.: 10.0Max.: 100.0 285u S7: Output Current LimitNo.(Addr.Hex) Name Description Values PageS7-01(324B)<1> Output Current Limit SelectSets the function to enable and disable the output current regulator.0: Disabled1: EnabledDefault: 0Range: 0, 1 –S7-02(324C)<1> Current Limit Sets the current limit. The value is internally limited to 300% of drive ratedcurrent.Default: 0.0 AMin.: 0.0Max.: 1000.0 –S7-10(3250)<1>Single Phase FoldbackSelectionSets the function to enable and disable the single-phase ripple regulator.0: Disabled1: EnabledDefault: 1Range: 0, 1 –S7-11(3251)<1> Ripple Regulator Setpoint Set as a percentage of the maximum amount of ripple allowed before the drivewill detect and input phase loss fault.Default: 95.0%Min.: 0.0Max.: 200.0 –<1> Available in drive software versions PRG: 8503 and later.B.12 S: Special ApplicationYASKAWA SIEP YAIP1U 01C AC Drive - P1000 Technical Manual 477B Parameter List