Table 2.2 Installation EnvironmentKeypad Kit Model DescriptionUUX000526 Blank label on the front.UUX000527 Yaskawa brand label on the front.Installation Types and Required MaterialsThe digital operator mounts to an enclosure two different ways:• External/face-mount installs the operator outside the enclosure panel• Internal/flush-mount installs the operator inside the enclosure panelTable 2.3 Digital Operator Installation Methods and Required ToolsInstallationMethod Description InstallationSupport Sets Model Required ToolsExternal/Face-MountSimplified installation withthe digital operator ismounted on the outside ofthe panel with two screws.– – Phillips screwdriver(#1)Internal/Flush-MountEncloses the digitaloperator in the panel. Thefront of the digital operatoris flush with the outside ofthe panel.Installation Support Set A(for mounting with screwsthrough holes in the panel) EZZ020642A Phillips screwdriver(#1, #2)Installation Support Set B(for use with threaded studsthat are fixed to the panel) EZZ020642B Phillips screwdriver (#1)Wrench (7 mm)NOTICE: Prevent foreign matter such as metal shavings or wire clippings from falling into the drive during installation and projectconstruction. Failure to comply could result in damage to the drive. Place a temporary cover over the top of the drive during installation.Remove the temporary cover before drive start-up, as the cover will reduce ventilation and cause the drive to overheat.External/Face-Mount1. Cut an opening in the enclosure panel for the digital operator as shown in Figure 2.12.2. Position the digital operator so the display faces outwards, and mount it to the enclosure panel as shown in Figure2.11.Digital Operator M3 x 6Phillips recessedpan head machine screw x 2Enclosure panelUnit: mmFigure 2.11 External/Face-Mount Installation2222142622782Unit: mmFigure 2.12 Panel Cut-Out Dimensions (External/Face-Mount Installation)2.2 Mechanical InstallationYASKAWA SIEP YAIP1U 01C AC Drive - P1000 Technical Manual 532 Mechanical Installation
