n Vertical Suspension of Drive Models 2A0360, 2A0415, and 4A0250 to 4A1200Models 2A0360, 2A0415, and 4A0250 to 4A0675When vertical suspension of the drive is required in an enclosure panel, change the orientation of the eye bolts for these modelsby turning the eye bolts counterclockwise 90 degrees.Figure 2.6 Adjusting Angle of Eye BoltsModels 4A0930 and 4A1200When suspending models 4A0930 or 4A1200 with wires, follow the procedure described below.WARNING! Crush Hazard. Use an adequate length of wire to ensure a 50° or wider suspension angle as illustrated in Figure 2.8. Themaximum allowable load of the eye bolts cannot be guaranteed when the drive is suspended with the wires at angles less than 50°. Failureto comply may result in serious injury or death from falling equipment.1. Remove the four eye bolts from the drive side panels and fix them securely on the top panel.Eye boltFigure 2.7 Eye Bolt Repositioning2. Pass wire through the holes of all four eye bolts.ABCA – Eye boltB – WiresC – Suspending angle: 50° or greaterFigure 2.8 Suspension Wire Angle Example2.2 Mechanical InstallationYASKAWA SIEP YAIP1U 01C AC Drive - P1000 Technical Manual 512 Mechanical Installation
