3. Gradually take up the slack in the wires and hoist the drive after the wires are stretched tight.4. Lower the drive when ready to install in the enclosure panel. Stop lowering the drive when it is near the floor thenbegin lowering the drive again very slowly until the drive is placed correctly.u Digital Operator Remote Usagen Remote OperationThe digital operator mounted on the drive can be removed and connected to the drive using a remote control extension cableup to 3 m long to facilitate operation when the drive is installed in a location where it cannot be easily accessed.The digital operator can also be permanently mounted remote locations such as panel doors using a remote control extensioncable and an installation support set (depending on the installation type).Note: Refer to Drive Options and Peripheral Devices on page 376 for information on remote control extension cables and installation supportsets.S/N : J007XE273710001OperatorDriveCommunication Cable ConnectorComm PortFigure 2.9 Communication Cable Connectionn Digital Operator Remote InstallationDigital Operator DimensionsS/N : J007XE273710001907860 7.95012.2 1.64415Installation holes (2-M3 screws, depth 5)minimumUnit: mmFigure 2.10 Digital Operator DimensionsNEMA Keypad KitsProvides digital operator functionality on an enclosure designed for IP20/NEMA 1, UL Type 1; NEMA 3R, UL Type 3R;NEMA 4, UL Type 4; NEMA 4X, UL Type 4X; NEMA 12, UL Type 12; or IPX6 environment.2.2 Mechanical Installation52 YASKAWA SIEP YAIP1U 01C AC Drive - P1000 Technical Manual