C.4 MEMOBUS/Modbus Setup Parametersu MEMOBUS/Modbus Serial CommunicationChanges to MEMOBUS/Modbus communications settings become effective after restarting the drive.n H5-01: Drive Node AddressSets the drive station node number (address) for MEMOBUS/Modbus terminals R+, R-, S+, S- . .Note: Cycle the power after changing this parameter to enable the new setting.No. Name Setting Range DefaultH5-01 Drive Slave Address 1F (Hex)n H5-02: Communication Speed SelectionSets the MEMOBUS/Modbus communications speed.Note: Cycle the power after changing this parameter to enable the new setting.No. Name Setting Range DefaultH5-02 Communication Speed Selection 0 to 8 3H5-02 Communication Speed H5-02 Communication Speed0 1200 bps 5 38400 bps1 2400 bps 6 57600 bps2 4800 bps 7 76800 bps3 9600 bps 8 115200 bps4 19200 bpsn H5-03: Communication Parity SelectionSets the parity used for communications.Note: Cycle power for the setting to take effect.No. Name Setting Range DefaultH5-03 Communication Parity Selection 0 to 2 0Setting 0: No paritySetting 1: Even paritySetting 2: Odd parityn H5-04: Stopping Method after Communication ErrorSelects the stopping method after a communications error (CE) has occurred.No. Name Setting Range DefaultH5-04 Stopping Method after CE 0 to 3 3Setting 0: Ramp to stop (uses the deceleration time currently enabled)Setting 1: Coast to stopSetting 2: Fast StopSetting 3: Alarm only (continue operation)n H5-05: Communication Fault Detection SelectionEnables or disables the CE detection for communications.No. Name Setting Range DefaultH5-05 Communication Fault Detection Selection 0 or 1 1Setting 0: DisabledNo communication error detection. The drive continues operation.C.4 MEMOBUS/Modbus Setup ParametersYASKAWA SIEP YAIP1U 01C AC Drive - P1000 Technical Manual 511C MEMOBUS/ModbusCommunications