BRKT Bracket unit7-19 69J3D113. Install the tilt ram upper end into theswivel bracket with the shaft 4 and cir-clip 5.4. Tighten the self-locking nut 6 to thespecified torque.5. Remove the anode 7.6. Inject grease into all grease nipples untilgrease comes out from the bushings a.Adjusting the trim sensor1. Fully tilt the outboard motor up, and thensupport it with the tilt stop lever 1.WARNINGAfter tilting up the outboard motor, besure to support it with the tilt stop lever.Otherwise, the outboard motor could sud-denly lower if the power trim and tilt unitshould lose fluid pressure.2. Loosen the cam screws 2.3. Adjust the position of the trim sensor,and then tighten the screws 2 fingertight.4. Fully tilt the outboard motor down.5. Measure the trim sensor resistance.Repeat steps 1–5 if out of specification.6. Tighten the screws 2.Trim sensor resistance:Pink (P) – Black (B)9–11 Ω at 20 °C (68 °F)
