69J3D11 3-10123456789Adjusting the throttle link andthrottle cable operation (with a stopbolt)NOTE:• Be sure to synchronize the throttle valvesbefore adjusting the throttle link.• For synchronizing procedures, see Chapter4, “Synchronizing the throttle valve.”1. Loosen the locknut 1, remove the clip2, and then disconnect the throttle cablejoint 3.2. Loosen the locknut 4 and disconnect thelink rod 5 from the magnet control lever6.3. Install the stop bolt (general bolt) 7 intothe threaded hole.4. Push the throttle control lever 8 againstthe stop bolt 7.NOTE:Use a general bolt with the specified mea-surements.5. Push the magnet control lever 6 in thedirection of the arrow to eliminate anylooseness, and then adjust the link rod 5so that it aligns with the magnet controllever joint 9.6. Install the link rod 5 and tighten the lock-nut 4.7. Remove the stop bolt 7.8. Check that the alignment mark d isbetween the alignment mark e. If not,repeat steps 2–6.Stop bolt 7:a: 10 mm (0.39 in)b: 6.0 mm (0.24 in)c: 1.0 mm (0.04 in)Power unit / Control system
