69J3D11 3-14123456789NOTE:• To increase the idle speed, turn the throttlestop screw in direction a.• To decrease the idle speed, turn the throttlestop screw in direction b.7. Tighten the port throttle stop screw 5until it contacts the throttle body lever 6.8. Loosen the locknut 8, remove the clip9, and then disconnect the throttle cablejoint 0.9. Adjust the link rod 3 so that the align-ment mark c is between the alignmentmarks d. Then, push the magnet controllever 4 in the direction of the arrow toeliminate any looseness.10. Install the link rod 3, and then tightenthe locknut 2.11. Check that the alignment mark c isbetween the alignment marks d. If nec-essary, repeat steps 8–10.12. Place the throttle cam A against the fullyclosed stopper e, and check that thereis a minimum clearance f of approxi-mately 1.0 mm (0.04 in).13. Adjust the position of the throttle cablejoint until its hole is aligned with the setpin g on the throttle cam.Control system
