BRKT Bracket unit7-37 69J3D112. Install the tilt cylinder end screw 6,spring 7, adapter 8, and tilt piston 9 tothe tilt ram 5.3. Hold the tilt piston in a vise using thespecial service tool A on both sides.4. Tighten the tilt ram 0 to the specifiedtorque.5. Install the new O-ring C and backup ringD into the tilt piston 9.6. Install the balls E, absorber valve pinsF, and springs G as shown.7. Install the washers H, plate I, and boltJ to the tilt piston 9, and then tightenthe bolt to the specified torque.Assembling the trim rams1. Install the trim piston 1 to the trim ram2.2. Hold the trim ram 2 in a vise using alu-minum plates a on both sides.3. Tighten the trim piston bolt to the speci-fied torque.PTT piston vice attachment A:90890-06572Tilt rod wrench B: 90890-06569T R..Tilt ram 0:55 N·m (5.5 kgf·m, 40 ft·lb)T R..Tilt piston bolt J:7 N·m (0.7 kgf·m, 5.1 ft·lb)
