69J3D11 7-40123456789NOTE:Align the armature shaft with the recess inthe joint.Installing the reservoir1. Install the spacer 1, filter 2 and sheet3 to the cylinder block.2. Install the new O-ring 4 and reservoir5, and then tighten the bolts 6 to thespecified torque.3. Install the reservoir cap 7, and thentighten it to the specified torque.Installing the tilt ram1. Fill the tilt cylinder with the recommendedfluid to the correct level a as shown.2. Add a small amount of the recommendedfluid through the cylinder block hole b asshown.3. Install the tilt piston assembly into the tiltcylinder, and then tighten the tilt cylinderend screw 1 to the specified torque.T R..PTT motor bolt 4:18 N·m (1.8 kgf·m, 13 ft·lb)T R..Reservoir bolt 6:18 N·m (1.8 kgf·m, 13 ft·lb)Reservoir cap 7:7 N·m (0.7 kgf·m, 5.1 ft·lb)Recommended power trim and tiltfluid:ATF Dexron IIPower trim and tilt unit
