69J3D11 3-121234567895. Check that the alignment mark a isbetween the alignment marks b. If not,repeat steps 2–4.6. Place the throttle cam 7 against the fullyclosed stopper c, and check that thereis a minimum clearance d of approxi-mately 1.0 mm (0.04 in).7. Adjust the position of the throttle cablejoint until its hole is aligned with the setpin e on the throttle cam.CAUTION:The throttle cable joint must be screwedin a minimum of 8.0 mm (0.31 in) f.8. Connect the cable joint, install the clip,and then tighten the locknut.9. Check the throttle cable for smooth oper-ation and adjust the cable length, if nec-essary, repeating steps 1–7.Checking the gearshift operation1. Check that the gearshift operatessmoothly when shifting from neutral intoforward or reverse. Adjust the shift cablelength if necessary.2. Set the gearshift to the neutral position.3. Loosen the locknut 1, remove the clip2, and then disconnect the shift cablejoint 3.4. Align the set pin a in the center of theshift bracket and with the alignmentmarks b on the bracket.S69J3340Control system
