Panasonic A230 User Manual

Communications (Serial and Parallel) OCR Type A23016 − 1416.2 Communication Settings4413.Numerical CalculationSelect whether or not to output the results of numerical calculation in thecase that When handshaking is being performed.If you want to output numerical calculation data, select 8−bit, 16−bit, or32−bit as the output data length from the Numerical Calculation menu.Refer to 13.3 Numerical Calculation for details.4414.JudgmentSelect whether or not to output judgment results in the case that Whenhandshaking is being performed.NoteIf you will use handshaking, it is not possible to set both “4413.Numerical Calc.” and “4414. Output” for no output. One of thetwo must be set for output.442. Reset Cond.Select one of the following three methods for resetting the paralleloutput data.Latch (factory setting): Hold until output of the next inspection result.Off after image capture: Reset (switch off) after completion of the nextinspection image capture.Off before image capture: Reset (OFF) before starting the nextinspection image capture (after detecting thestart signal).For a detailed timing chart, refer to Data Switching Timing(page 16 − 27).443. Setting TemplateSet whether or not to re−register the Smart Matching template usingparallel input, and select one of the following four execution methods.No: Do not re−register, even if the re−registersignal is input.Setting position: Execute re−registration at the position thatthe template area was set.Execution position: Execute the matching checker, andre−register at the detected position(or the position with the highest correlation inthe case that multiple objects are detected).Adjustment position: Execute the Position Adjustment checker, andperform re−registration at the position where thetemplate area was first set within the correctedsearch area.Refer to 16.8 Template (Smart Matching) Re−registration for details.