Panasonic A230 User Manual
                                                                                                                                                                                                                                                                                                                                                                                         |
Communications (Serial and Parallel)OCR Type A23016 − 2516.4 Inspection Execution and Result Output Procedures(E): When you have confirmed that STROB on, switch ACK on.At this point, if ACK does not go from off to on within the timeout period (To), handlethis as a timeout and abort communication.(F): After confirming that ACK is on, wait for Td, and then turn STROB off.(G): After confirming that STROB is off at the external device, switch ACK off.(H): After confirming that ACK is off, wait for Td for the next data (D1 to D8) output.Repeat for the number of times required for the amount of data.(I): After the required number of data output cycles, confirm that ACK is off, wait forTd, perform checker drawing and other post processing, and then switch READYto on.At the same time, REND will change to off.− Data Bit AssignmentIn the case of 8−bit data:Judgment output bit assignment(in the case that one or more of JD09 to JD16 has been specified)First timeSecond timeBit assignmentNumerical calculation bit assignmentIn the case of 8−bit output data:In the case of 16−bit output data:In the case of 32−bit output data: |
Related manuals for Panasonic A230
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine