Panasonic A230 User Manual

Environment and Product Type OCR Type A2305 − 65.2 Environment Settings (Environment settings common for all types)13. FlashSet to Yes in the case that you wish to use flash illumination. Set this whenyou have selected Normal Frame for the camera mode. This initial setting isUnused.FlashYesUnusedYes(ANM830A)NoteIf the standard camera being used is the ANM830A, set this toYes (ANM830A).5.2.3 StartSet the inspection start method.Repeated inspection is only possible with the Main menu (Checker and Spreadsheets),Numerical Calculation menu, Judgment menu and Spreadsheets menu.− OnceWhen A is pressed, or if a start input is received from the parallel interface ora start command is received from the serial interface, a single inspection isperformed.− Manual RepeatWhen A is pressed, or if a start input is received from the parallel interface ora start command is received from the serial interface, continuous repeatedinspection commences until A is pressed again. (Inspection stops even ifanother start input is received from the parallel or serial interface.)− Auto RepeatContinuous repeated inspection commences as soon as the power is turned on.Inspection stops when A is pressed. After inspection stops, restarting is thesame as for Repeat (manual).A button Parallel start Serial (%S) Serial (%P) Serial (%R)Once Single inspection Single inspection Single inspection Single inspection Single inspectionManual Repeat/Auto RepeatContinuousinspectionContinuousinspectionContinuousinspectionContinuousinspectionSingle inspection