POWR Power unit5-11 67C3K115. Install the spiral spring 8 into the manualstarter cover 9.NOTE:Hook the end c of the spiral spring 8 ontothe cut-out d in the manual starter cover 9.6. Install the sheave drum 2 into the man-ual starter cover 9.NOTE:• When installing the sheave drum 2, set thespiral spring 8 by turning the drum.• Hook the end e of the spiral spring 8 ontothe cut-out f in the sheave drum 2.7. Install drive pawl spring 1 =, the driveplate A, and the bolt B.8. While holding the starter rope 1, turn thesheave drum 2 3 turns in the direction ofthe arrow shown.NOTE:Push the starter plunger 3 in the direction ofthe arrow shown while turning the sheavedrum 2 as shown.9. Remove the starter rope 1 from thenotch b, and then fit it into the groove inthe sheave drum 2.NOTE:• Be sure to hold the sheave drum 2 withyour hand so that it turns slowly.• Allow the spring force to slowly turn thedrum as the starter rope winds around thedrum.10. Pull the starter handle 7 several times tocheck that the sheave drum turnssmoothly and to check the starter ropefor slack. Repeat steps 4–9 if necessary.NOTE:Push the starter plunger 3 in the direction ofthe arrow shown while pulling the starter han-dle 7.S67C503489 c dS67C503529fe8S67C5036LT2710AA BS67C503731b2S67C503873 3
