BRKT Bracket unit7-49 67C3K114. Hold the tilt ram in a vise using aluminumplates a on both sides.5. Install the balls 0, absorber valve pinsA, springs B, and balls C as shown.6. Install the washer D and bolt E to the tiltpiston 8, and then tighten the bolt to thespecified torque.7. Install the PTT gear pump housing to thetilt cylinder.NOTE:To install the PTT gear pump housing, see“Assembling the gear pump” (7-44).8. Fill the cylinder with the recommendedPTT fluid to about 60%.9. Install a new O-ring F to the free pistonG, and then install the piston into the cyl-inder H.10. Place the tilt cylinder end screw 5 at thebottom of the tilt ram 9.11. Install the tilt ram assembly into the cylin-der.12. Tighten the tilt cylinder end screw 5 tothe specified torque.T R..Tilt piston bolt E:61 N·m (6.1 kgf·m, 45.0 ft·lb)Recommended PTT fluid:ATF Dexron IIS67C7097a aCBA0CEDBA08LT271S67C7100H GFS67C710195
