67C3K11 8-18123456789NOTE:• To prevent the engine from starting whencranking it, be sure to disconnect all sparkplug caps.• Do not remove the clip from the engineshut-off switch.• If measuring the output peak voltage underthe unloaded conditions, disconnect thecharge coil connectors.• When using the manual starter to crank theengine to measure the output peak voltageunder the loaded conditions, turn theengine start switch to “ON” (W model).• When using the manual starter to crank theengine, the voltage values may varydepending on the speed at which thestarter handle is pulled.2. Disconnect the charge coil connectors.3. Measure the charge coil resistance.Replace if out of specification.4. Connect the charge coil connectors.Checking the engine shut-off switch(M model)1. Disconnect the engine shut-off switch 1connector and ground terminal.Charge coil output peak voltage:White/green (W/G) –Green/white (G/W)r/min Unloaded LoadedCranking 1,500 3,500DC V 200 190 200 200Charge coil resistance (referencedata):White/green (W/G) –Green/white (G/W)660–710 Ω at 20 °C (68 °F)S67C8045WWB171Ignition and ignition control system
