BRKT Bracket unit7-31 67C3K112. Install the collar 1 onto the hydraulic tiltunit 2.3. Install the hydraulic tilt unit 2, collar 3,bushings 4, shaft 5, and washers 6onto the clamp brackets 7, and thentighten the bolts 8.4. Install a bushing 9 to the hydraulic tiltunit 2 and install a bushing 9 and thebushing 0 to the swivel bracket.5. Install the hydraulic tilt unit 2, shaft A,and E-clips B to the swivel bracket.6. Apply grease to all grease nipples until itcomes out from the areas a.Installing the PTT unit1. Tilt the outboard motor to the fully upposition, and then support it with the tiltstop lever.WARNINGAfter tilting the outboard motor up, besure to support it with the tilt stop lever.2. Install the bushing 1 onto the PTT unit2.3. Install the PTT unit 2, bushings 3, shaft4, and washers 5 onto the clampbrackets 6, and then tighten the bolts7.4. Install a bushing 8 to the PTT unit 2and install a bushing and the bushing 9to the swivel bracket.5. Install the PTT unit 2, shaft 0, and E-clips A to the swivel bracket.6. Install the ground lead terminals B andC to the PTT unit 2.S67C7124AAAAAAAALT242LTLT242LTBA8650446 8321B799S67C3053AaS67C7123S67C7055AAAAAAAAALT242LTLT242LTA097 5 436135 7BC288
