POWR Power unit5-51 67C3K116. Install the oil seals A and B onto thecrankshaft C as shown, and then installthe crankshaft into the cylinder block.NOTE:Apply engine oil to the inside of each oil sealbefore installation.7. Install the connecting rod caps D to theconnecting rods, and then tighten thebolts to the specified torques in 2 stages.NOTE:• Make sure that the projections f on theconnecting rod cap D face towards the fly-wheel magnet end È of the crankshaft.• Apply engine oil to the connecting rod capbolts before installation.• After tightening the connecting rod capbolts, check that the crankshaft rotatessmoothly.8. Install the remaining half of the mainbearings into the crankcase.NOTE:• Install the main bearings in their originalpositions.• Insert the projection of each bearing intothe slots in the crankcase.9. Apply sealant to the mating surface ofthe crankcase.NOTE:Do not get any sealant on the main bearings.10. Install the crankcase onto the cylinderblock, and then tighten the crankcasebolts to the specified torques in 2 stagesand in the sequence shown.NOTE:Apply engine oil to the threads of the crank-case bolts before installation.S67C5153BAEECS67C5154EED ÈfT R..Connecting rod cap bolt:1st: 6 N·m (0.6 kgf·m, 4.4 ft·lb)2nd: 17 N·m (1.7 kgf·m, 12.5 ft·lb)S67C5155E518S67C51451 2345 6789 0ABC DEF EE
